Citroën Relay Van Free Workshop and Repair Manuals

To adjust the headlights, park the van on level ground facing a wall. Turn on the headlights and locate the adjustment screws on the headlight assembly. Adjust the screws to align the headlights with the marks on the wall.

To check and replace the fuse, locate the fuse box and use the fuse diagram in the owner’s manual to identify the fuse associated with the faulty component. Pull the fuse out and check if it is blown. Replace it with a new fuse of the same amperage rating.

To check the serpentine belt, locate the belt and inspect it for signs of wear or damage. If it needs to be replaced, use a belt tensioner tool to release the tension and remove the old belt. Install the new belt according to the belt routing diagram in the owner’s manual and release the tensioner.

To check and replace the transmission fluid, locate the transmission dipstick and check the fluid level with the engine running and the transmission in park. If the level is low, add the appropriate transmission fluid recommended by the manual. To replace the fluid, use a fluid pump to remove the old fluid from the transmission pan and replace it with new fluid.

To check the oil level, make sure the van is on level ground and the engine is off. Locate the dipstick, pull it out and wipe it clean. Reinsert the dipstick fully and remove it again to read the oil level. If the level is low, add the appropriate oil type and quantity recommended by the manual.

To replace the air filter, locate the air filter housing and remove the clips or screws securing the cover. Take out the old air filter and replace it with a new one. Make sure the housing cover is securely fastened.

To replace the alternator, first disconnect the negative battery cable. Remove the drive belt and any brackets or bolts securing the alternator. Disconnect the electrical connections to the alternator and remove it. Replace it with a new alternator and reconnect the electrical connections and brackets.

To replace the battery, locate the battery and remove the negative cable first, then the positive cable. Remove any brackets or screws securing the battery and lift it out. Replace it with a new battery and reconnect the cables in reverse order.

To replace the brake pads, first remove the wheel and locate the brake caliper. Remove the caliper bolts and carefully lift the caliper off the rotor. Remove the old brake pads and replace them with new ones. Put the caliper back in place and secure it with the bolts.

To replace the fuel filter, locate the fuel filter and relieve the fuel system pressure. Disconnect the fuel lines from the filter and remove the mounting bolts or clips. Replace the old filter with a new one and reconnect the fuel lines.

To replace the spark plugs, locate the spark plug wires and remove them from the spark plugs. Use a spark plug wrench to remove the old plugs and replace them with new ones. Reinstall the spark plug wires in the correct order.

To replace the wiper blades, lift the wiper arm away from the windshield and press the release tab on the blade. Slide the blade off the arm and install the new blade in the reverse order. Repeat for the other wiper blade.

The engine coolant level should be between the minimum and maximum marks on the coolant reservoir. It is important to maintain the proper coolant level to prevent engine overheating and damage.

The recommended tire pressure can be found on the tire placard on the driver’s side door jamb or in the owner’s manual. It is important to maintain the recommended tire pressure to ensure proper handling, fuel efficiency, and tire longevity.

The recommended oil type and viscosity can be found in the owner’s manual. It is important to use the correct oil type to ensure engine longevity and performance.