The Sunrunner is a Pontiac version of Chevrolet Tracker produced in period from 1990 to 1998.Launched in 1989 as both the Chevy and GMC Tracker, it was originally a two-door small sport-ute sold with either a canvas or hard top. The 80-horsepower, 1.6-litre engine has proved durable if uninteresting in terms of performance. Just avoid the automatic if you plan to pass anyone, ever.For the most part, the Tracker was unchanged through 1998, except for the addition of a four-door version in 1997. Tall and narrow, the Tracker should be driven carefully in turns. The high centre of gravity means you must cope with plenty of body lean. Still, the ride is choppy, not to mention noisy.On the plus side, a Tracker’s interior is surprisingly roomy given the modest exterior dimensions. Yes, the back seat is more a place for kids, but the tall seating position at least provides a good view of the road and reasonable thigh support.
Frequently Asked Questions
How do I change a flat tire on my Pontiac Sunrunner?
To change a flat tire on your Pontiac Sunrunner, first, locate the spare tire, jack, and lug wrench in the trunk. Find a stable and level surface to park the vehicle and engage the parking brake. Use the lug wrench to loosen the lug nuts slightly before jacking up the vehicle. Once the vehicle is raised, fully remove the lug nuts and take off the flat tire. Install the spare tire, hand-tighten the lug nuts, and then lower the vehicle. Finally, use the lug wrench to fully tighten the lug nuts in a star pattern.
How do I change the oil in my Pontiac Sunrunner?
To change the oil in your Pontiac Sunrunner, first, locate the oil drain plug under the engine. Use a socket or wrench to remove the plug and let the old oil drain into a suitable container. Once all the oil has drained, replace the drain plug and remove the oil filter. Apply a thin layer of oil to the new filter gasket and install the new filter. Finally, refill the engine with the recommended amount and type of oil.
How do I check and adjust the tire pressure on my Pontiac Sunrunner?
To check and adjust the tire pressure on your Pontiac Sunrunner, start by referring to the vehicle’s manual or the sticker located on the driver’s side door jamb for the recommended tire pressure. Use a tire pressure gauge to measure the current tire pressure. If the pressure is too low, add air using a compressor or gas station air pump until it reaches the recommended level. If the pressure is too high, release air by pressing the valve stem with a small tool until the desired pressure is achieved. Repeat this process for all four tires, and don’t forget to check the spare tire as well.
How do I diagnose and fix a misfiring engine in my Pontiac Sunrunner?
If your Pontiac Sunrunner’s engine is misfiring, start by checking the spark plugs and ignition system for any signs of wear or damage. Replace any faulty spark plugs or ignition components as necessary. Inspect the fuel system, including the fuel injectors and fuel filter, for clogs or leaks. Clean or replace any components that are obstructed or malfunctioning. Additionally, check the engine’s compression to ensure proper cylinder pressure. If the issue persists, it may be necessary to consult a professional mechanic for further diagnosis and repair.
How do I jump-start my Pontiac Sunrunner?
To jump-start your Pontiac Sunrunner, first, position both vehicles in close proximity with their engines turned off. Attach one end of the positive (red) jumper cable to the positive terminal of the dead battery, then connect the other end to the positive terminal of the charged battery. Next, connect one end of the negative (black) jumper cable to the negative terminal of the charged battery, and attach the other end to a grounded metal surface of the dead vehicle, such as an unpainted bolt or bracket. Start the engine of the charged vehicle and let it run for a few minutes. Then, attempt to start the dead vehicle. Once the dead vehicle starts, remove the jumper cables in the reverse order.
How do I replace a blown fuse in my Pontiac Sunrunner?
To replace a blown fuse in your Pontiac Sunrunner, locate the fuse box, which is usually found under the dashboard or in the engine compartment. Open the fuse box cover and consult the vehicle’s manual or the fuse box lid for a diagram of the fuse layout. Identify the fuse corresponding to the malfunctioning circuit and use a fuse puller tool or a pair of needle-nose pliers to remove the blown fuse. Replace the blown fuse with a new one of the same rating, making sure it is securely seated. Finally, close the fuse box cover and test the circuit to ensure proper functionality.
How do I replace a malfunctioning headlight bulb in my Pontiac Sunrunner?
To replace a malfunctioning headlight bulb in your Pontiac Sunrunner, open the hood and locate the rear of the headlight assembly. Find the electrical connector attached to the bulb and disconnect it by pulling it straight out. Remove any retaining clips or covers that may be securing the bulb in place. Carefully remove the old bulb by twisting it counterclockwise and pulling it straight out. Install the new bulb by aligning the tabs or notches and twisting it clockwise until it locks into place. Reconnect the electrical connector and test the headlight before closing the hood.
How do I replace the battery in my Pontiac Sunrunner?
To replace the battery in your Pontiac Sunrunner, start by turning off the engine and ensuring all electrical accessories are turned off. Locate the battery, usually found in the engine compartment. Disconnect the negative (black) battery cable first, followed by the positive (red) cable. Remove any battery hold-down brackets or clamps, then carefully lift out the old battery. Clean the battery tray if necessary, then place the new battery in the tray. Reconnect the positive cable first, followed by the negative cable. Finally, start the engine and verify that all electrical components are functioning properly.
How do I replace the brake pads on my Pontiac Sunrunner?
To replace the brake pads on your Pontiac Sunrunner, start by safely raising and supporting the vehicle. Remove the wheels and locate the brake caliper assembly. Use a suitable tool to compress the caliper piston, then remove the caliper mounting bolts and carefully remove the caliper. Next, remove the old brake pads and inspect the caliper and rotor for any signs of damage or wear. Install the new brake pads, making sure they are properly aligned, and reassemble the caliper. Finally, reinstall the wheels and test the brakes before driving the vehicle.
How do I replace the windshield wipers on my Pontiac Sunrunner?
To replace the windshield wipers on your Pontiac Sunrunner, lift the wiper arm away from the windshield and locate the release tab or button on the wiper blade assembly. Press or slide the tab/button to release the old wiper blade and remove it from the wiper arm. Align the new wiper blade with the arm, ensuring that the hook or clip is securely attached. Press the blade firmly until it clicks into place. Repeat the process for the other wiper blade, and test the new blades by activating the windshield wipers.
How do I troubleshoot a faulty power window in my Pontiac Sunrunner?
If you are experiencing issues with a power window in your Pontiac Sunrunner, start by checking the fuse and relay associated with the power window circuit. If the fuse and relay are functioning properly, inspect the wiring and connectors for any signs of damage or loose connections. Use a multimeter to test for voltage at the power window switch and motor. If voltage is present but the window still doesn’t operate, the motor or regulator may need to be replaced. However, if there is no voltage, further diagnosis may be required to identify the exact cause of the issue.
How do I troubleshoot a non-responsive air conditioning system in my Pontiac Sunrunner?
If the air conditioning system in your Pontiac Sunrunner is not responding, start by checking the refrigerant level using a pressure
How often should I replace the engine air filter in my Pontiac Sunrunner?
It is recommended to replace the engine air filter in your Pontiac Sunrunner every 15,000 to 30,000 miles or as specified in your vehicle’s maintenance schedule. However, the replacement frequency may vary depending on driving conditions, such as dusty or polluted environments. A clogged or dirty air filter can restrict airflow to the engine, reducing performance and fuel efficiency. Therefore, regular inspection and replacement of the air filter is essential to maintain optimal engine performance.
What type of coolant should I use in my Pontiac Sunrunner?
To ensure optimal performance and prevent engine overheating, it is recommended to use a high-quality, ethylene glycol-based coolant with a 50/50 mix of coolant and distilled water. Avoid using plain water or mixing different types of coolant, as this can lead to corrosion and decreased cooling efficiency. Refer to your Pontiac Sunrunner automotive repair manual for specific coolant recommendations and instructions on how to properly fill and bleed the cooling system.
Pontiac Sunrunner Related Models