The koda 130/135/136 are three variations of a rear-engined, rear-wheel drive family car that was produced by Czechoslovakian car manufacturer AZNP in Mlad? Boleslav between 1984 and 1990. The very first koda 130 models were introduced in August 1984. The 130 series used a new 1289 cc engine (which produced 58 PS (43 kW), and which was just an enlarged version of the 1174 cc engine used in the 120 series). The 130/135/136 series also had a five-speed gearbox, semi-trailing arm rear suspension, wider track and four-pot front brake disc calipers (the latter two of which were already in use in the 105/120 series). The Saloon versions of the new 130 series were available in 130 L and 130 GL forms.
Frequently Asked Questions
How can I reset the service indicator on my Skoda 135?
To reset the service indicator on your Skoda 135, you will need to access the instrument cluster controls. Turn the ignition key to the “On” position (do not start the engine) and simultaneously press and hold the trip reset button. Keep the button pressed until the service indicator resets, which is usually indicated by a message or symbol disappearing from the display. Release the button and start the engine to verify if the service indicator has been successfully reset.
How do I adjust the side mirrors in my Skoda 135?
To adjust the side mirrors in your Skoda 135, locate the mirror control switch on the driver’s door panel. Use the switch to select the desired mirror (left or right) or the mirror adjustment wheel, depending on the vehicle’s configuration. Move the switch or wheel in the appropriate direction to adjust the mirror’s position. It is recommended to adjust the mirrors so that you have a clear view of the rear and side of your vehicle, minimizing blind spots.
How do I change the oil in my Skoda 135?
To change the oil in your Skoda 135, you will need to locate the oil drain plug underneath the engine and remove it using a wrench. Once the oil has fully drained out, replace the drain plug and remove the oil filter. Install a new oil filter and pour in the recommended amount of new oil, making sure to use the correct viscosity for your vehicle.
How do I jump-start my Skoda 135?
To jump-start your Skoda 135, you will need a set of jumper cables and a functioning vehicle with a compatible battery. Park the two vehicles close to each other, turn off both engines, and locate the battery terminals. Connect the positive terminal of the dead battery to the positive terminal of the charged battery using the red jumper cable. Then, connect the negative terminal of the charged battery to a metal surface of the dead vehicle, away from the battery. Start the engine of the charged vehicle and let it run for a few minutes before attempting to start the dead vehicle. Once started, remove the jumper cables in reverse order.
How do I replace a brake light bulb in my Skoda 135?
To replace a brake light bulb in your Skoda 135, open the trunk or liftgate and locate the access panel or cover behind the brake light assembly. Remove the panel or cover to reveal the bulb socket. Twist the socket counterclockwise to remove it and gently pull out the old bulb. Insert a new bulb into the socket, making sure it is securely seated, and reinsert the socket back into the assembly. Test the brake lights before reattaching the access panel.
How do I replace a cabin air filter in my Skoda 135?
To replace a cabin air filter in your Skoda 135, start by locating the filter housing, which is usually situated behind the glove compartment or under the dashboard. Remove the access panel or cover to reveal the filter. Take note of the filter’s orientation before removing it. Replace the old filter with a new one, ensuring it is properly aligned, and then reassemble the housing and cover. Regularly replacing the cabin air filter helps maintain clean and fresh air inside the vehicle.
How do I replace a headlight bulb in my Skoda 135?
To replace a headlight bulb in your Skoda 135, you will need to access the back of the headlight assembly by opening the hood. Locate the socket that holds the bulb and gently twist it counterclockwise to remove it. Carefully disconnect the electrical connector and remove the old bulb. Install a new bulb, making sure not to touch the glass portion, and reconnect the electrical connector before securing the socket back into place.
How do I replace a spark plug in my Skoda 135?
To replace a spark plug in your Skoda 135, start by locating the spark plug wires or ignition coil packs. Disconnect the wire or coil pack from the spark plug by gently pulling it straight up. Use a spark plug socket and ratchet to remove the old spark plug by turning it counterclockwise. Install a new spark plug, making sure it is properly gapped according to the manufacturer’s specifications, and tighten it clockwise. Reconnect the wire or coil pack and repeat the process for the remaining spark plugs. Regularly replacing spark plugs ensures optimal engine performance and fuel efficiency.
How do I replace a windshield wiper blade in my Skoda 135?
To replace a windshield wiper blade in your Skoda 135, lift the wiper arm away from the windshield and locate the release tab or button on the wiper blade assembly. Depress the tab or button and slide the old wiper blade off the wiper arm. Align the new wiper blade with the wiper arm and slide it in until it clicks into place. Gently lower the wiper arm back onto the windshield and repeat the process for the other wiper blade.
How often should I check the transmission fluid in my Skoda 135?
It is important to regularly check the transmission fluid level in your Skoda 135 to ensure smooth operation and prevent potential damage. The frequency of checking the transmission fluid can vary depending on the vehicle’s age and driving conditions. As a general guideline, it is recommended to inspect the transmission fluid every 30,000 to 60,000 miles or as specified in the owner’s manual. Follow the proper procedure outlined in the manual to check the fluid level accurately.
How often should I replace the air filter in my Skoda 135?
The air filter in your Skoda 135 should be replaced according to the manufacturer’s recommended intervals, which can be found in the owner’s manual. However, as a general guideline, it is advisable to inspect the air filter every 12,000 to 15,000 miles and replace it if it appears dirty or clogged. Regularly replacing the air filter ensures that clean air is being circulated in the engine, promoting better fuel efficiency and engine performance.
What is the recommended tire pressure for my Skoda 135?
The recommended tire pressure for your Skoda 135 can be found in the owner’s manual or on a sticker inside the driver’s side door jamb. It is crucial to maintain the proper tire pressure as specified by the manufacturer, as underinflated or overinflated tires can affect the vehicle’s handling, fuel efficiency, and tire lifespan. Regularly check your tire pressure using a reliable gauge and adjust it accordingly to ensure optimal performance and safety.
What should I do if my Skoda 135 is overheating?
If your Skoda 135 is overheating, it is important to take immediate action to prevent potential engine damage. Safely pull over to the side of the road, turn off the engine, and allow it to cool down. Check the coolant level and add more if necessary. If the coolant level is sufficient, there may be an issue with the radiator, water pump, thermostat, or other cooling system components. It is advisable to have your vehicle inspected by a qualified mechanic to diagnose and resolve the overheating issue.
What type of coolant should I use for my Skoda 135?
For your Skoda 135, it is recommended to use a coolant that meets the specifications outlined in the owner’s manual. Typically, a high-quality, ethylene glycol-based coolant with a 50/50 mix of coolant and distilled water is suitable for most climates. It is important to ensure that the coolant you choose is compatible with your vehicle’s cooling system and meets the necessary standards for your Skoda 135.
What type of engine oil should I use for my Skoda 135?
The recommended engine oil for your Skoda 135 can be found in the owner’s manual or on the oil cap. It is crucial to use the correct oil viscosity and quality as specified by the manufacturer to ensure optimal engine performance and longevity. Typically, a high-quality synthetic or conventional oil with the appropriate viscosity for your climate conditions is recommended. Regularly check the oil level and change the oil at the recommended intervals to maintain the engine’s health.
