
The SsangYong Korando is a sport utility vehicle (SUV) built by the South Korean automobile manufacturer SsangYong Motor from 1983 to 2006 and from 2010 onwards. It features a choice of 2.3 litre and 3.2 litre gasoline engines or 2.9 litre diesel engine; all produced on license from Mercedes-Benz, accompanied by a 5-speed manual Borg-Warner gearbox. The interior of the second generation Korando was unique because it had a steering wheel arch on either side. The third generation Korando was initially released with a 6-speed manual transmission and a 6-speed DSI model M11 automatic transmission and is in production from May 2011. It is also to be offered as a 2-wheel-drive or four-wheel-drive from launch. Its combined fuel consumption is 5.5 L/100 km and acceleration from 0 100 km takes less than 10 seconds. The engine available upon release was a 2.0 liter turbodiesel producing 175 horsepower. Petrol engine was introduced in 2012.
Frequently Asked Questions
How do I adjust the headlights on my Ssangyong Korando?
Properly aligned headlights are essential for optimal visibility and safety. To adjust the headlights on your Ssangyong Korando, park the vehicle on a level surface facing a wall or garage door. Measure the distance between the ground and the center of each headlight. Mark a horizontal line on the wall or door at the height of the headlights’ centers. Use the vertical adjustment screws located near the headlights to align the beams with the marks on the wall or door. For more precise instructions, consult the Ssangyong Korando automotive repair manual.
How do I change the engine oil in my Ssangyong Korando?
To change the engine oil in your Ssangyong Korando, you will need to locate the oil drain plug underneath the engine and remove it to drain the old oil. After draining the oil, replace the drain plug and remove the oil filter. Install a new oil filter, then refill the engine with the recommended amount and type of oil as specified in the Ssangyong Korando automotive repair manual.
How do I check the transmission fluid level in my Ssangyong Korando?
To check the transmission fluid level in your Ssangyong Korando, start by parking the vehicle on a level surface and engaging the parking brake. Locate the transmission dipstick, usually near the back of the engine compartment, and remove it. Wipe the dipstick clean, reinsert it fully, and then remove it again. The fluid level should be between the minimum and maximum markings on the dipstick as specified in the Ssangyong Korando automotive repair manual.
How do I jump-start my Ssangyong Korando?
If your Ssangyong Korando’s battery is dead, you can jump-start it using jumper cables and another vehicle with a charged battery. First, ensure both vehicles are turned off and parked facing each other. Connect the positive (red) jumper cable clamp to the positive terminal of the dead battery, then attach the other end to the positive terminal of the charged battery. Next, connect the negative (black) jumper cable clamp to the negative terminal of the charged battery and attach the other end to an unpainted metal surface in the engine compartment of the dead vehicle. Start the engine of the vehicle with the charged battery and let it run for a few minutes, then attempt to start the Ssangyong Korando. Refer to the Ssangyong Korando automotive repair manual for further details and precautions.
How do I replace a blown fuse in my Ssangyong Korando?
If you have a blown fuse in your Ssangyong Korando, you can replace it by first identifying the fuse box location, which is typically under the dashboard or in the engine compartment. Refer to the Ssangyong Korando automotive repair manual to locate the specific fuse related to the problem you are experiencing. Once identified, use a fuse puller or pliers to remove the blown fuse and replace it with a new fuse of the same amperage rating.
How do I replace the brake pads on my Ssangyong Korando?
To replace the brake pads on your Ssangyong Korando, first, ensure that the vehicle is safely secured on a level surface. Remove the wheel from the brake assembly you wish to work on, then locate and remove the caliper bolts to access the brake pads. Take note of the orientation of the old brake pads before removing them and install the new brake pads in the correct position as shown in the Ssangyong Korando automotive repair manual. Reinstall the caliper, tighten the caliper bolts, and repeat the process for other brake assemblies if necessary.
How do I replace the cabin air filter in my Ssangyong Korando?
To replace the cabin air filter in your Ssangyong Korando, locate the filter housing, which is usually behind the glove compartment or under the dashboard. Open the housing by removing the screws or clips securing it. Take note of the filter’s orientation and remove the old filter. Install the new cabin air filter in the correct position as indicated by the arrows or markings on the filter. Close the housing and secure it back in place. For specific instructions and filter replacement intervals, consult the Ssangyong Korando automotive repair manual.
How do I replace the windshield wipers on my Ssangyong Korando?
To replace the windshield wipers on your Ssangyong Korando, lift the wiper arm away from the windshield and locate the release tab or button on the wiper blade assembly. Press or slide the release mechanism to detach the old wiper blade from the arm. Align the new wiper blade with the arm and firmly press it into place until it clicks or locks. Repeat the process for the other wiper blade. For detailed instructions, including specific blade sizes and attachment methods, refer to the Ssangyong Korando automotive repair manual.
How do I reset the maintenance light in my Ssangyong Korando?
To reset the maintenance light in your Ssangyong Korando, start by turning the ignition key to the “ON” position without starting the engine. Fully press the accelerator pedal three times within a five-second interval. Afterward, turn the ignition key to the “OFF” position. Start the engine to confirm that the maintenance light has been reset. For further details and specific instructions, refer to the Ssangyong Korando automotive repair manual.
How do I troubleshoot a malfunctioning power window in my Ssangyong Korando?
If you are experiencing issues with a power window in your Ssangyong Korando, there are several potential causes to consider. Start by checking the fuse related to the power windows in the fuse box, as a blown fuse can prevent the windows from functioning. If the fuse is not the issue, examine the window switch, wiring, and motor for any signs of damage or malfunction. The Ssangyong Korando automotive repair manual provides detailed troubleshooting steps and diagrams to assist in diagnosing and resolving power window problems.
How often should I replace the air filter in my Ssangyong Korando?
The frequency of air filter replacement for your Ssangyong Korando depends on various factors, including driving conditions and the type of air filter used. However, as a general guideline, it is recommended to inspect and replace the air filter every 12,000 to 15,000 miles or as indicated by the maintenance schedule in the Ssangyong Korando automotive repair manual. A clogged or dirty air filter can restrict airflow to the engine, leading to decreased performance and fuel efficiency.
How often should I replace the timing belt in my Ssangyong Korando?
The timing belt in your Ssangyong Korando should be replaced at specific intervals as recommended by the manufacturer to prevent potential engine damage and failure. Consult the Ssangyong Korando automotive repair manual to determine the recommended timing belt replacement interval for your specific model and engine type. Typically, it is advised to replace the timing belt every 60,000 to 100,000 miles or as indicated by the maintenance schedule.
What is the recommended tire pressure for my Ssangyong Korando?
The recommended tire pressure for your Ssangyong Korando can be found in the Ssangyong Korando automotive repair manual. It is important to maintain the correct tire pressure as recommended by the manufacturer to ensure optimal performance, fuel efficiency, and tire longevity. Improper tire pressure can lead to uneven tire wear, decreased handling, and potential safety risks.
What type of coolant should I use in my Ssangyong Korando?
It is crucial to use the correct type of coolant in your Ssangyong Korando to maintain proper engine cooling and prevent overheating. Refer to the Ssangyong Korando automotive repair manual to determine the specific type of coolant recommended by the manufacturer. Typically, a coolant with a mixture of ethylene glycol and water in the appropriate ratio is used. Be sure to follow the instructions and guidelines provided in the manual for coolant selection and maintenance.

