Introduced in 1982, the Mitsubishi Montero is a medium to full size SUV by Mitsubishi Motors. It is known as Mitsubishi Pajero in Japan, Mitsubishi Montero in Spain, America (except Brazil) and India and Mitsubishi Shogun in the UK. Sold over 2.9 million until 20 12, this vehicle is now sold in its fourthgeneration iteration. The first two generations were offered as mid-size SUV while the latest generations are offered as full-size SUV. In 1988, a 3.0-litre SOHC V6 engine was made available, alongside a 2.5-litre turbo diesel engine, with the first 4×4 intercooler. This translated to better acceleration in mid to high rev ranges. The long-wheelbase models got a coil link suspension system for better ride comfort and off-road ability.
Frequently Asked Questions
How do I change the spark plugs in a Mitsubishi Montero?
To change the spark plugs in a Mitsubishi Montero, start by disconnecting the negative battery cable. Remove the engine cover if necessary, and locate the spark plug wires or ignition coils. Carefully remove the wires or coils, and use a spark plug socket and ratchet to remove the old spark plugs. Install the new spark plugs, tighten them to the recommended torque specification, and reattach the spark plug wires or ignition coils.
How do I check and adjust the tire pressure in a Mitsubishi Montero?
To check and adjust the tire pressure in a Mitsubishi Montero, start by finding the recommended tire pressure for your specific vehicle. This information can usually be found on a sticker inside the driver’s door jamb or in the owner’s manual. Use a tire pressure gauge to measure the pressure in each tire, and add or release air as needed to reach the recommended pressure. Be sure to check the spare tire as well.
How do I check the engine oil level in a Mitsubishi Montero?
To check the engine oil level in a Mitsubishi Montero, park the vehicle on a level surface and wait for the engine to cool down. Locate the dipstick, usually located near the front of the engine, and pull it out. Wipe the dipstick clean, reinsert it fully, and then pull it out again to check the oil level. The oil level should be between the low and high marks on the dipstick.
How do I diagnose a check engine light in a Mitsubishi Montero?
When the check engine light illuminates in a Mitsubishi Montero, it indicates that a fault has been detected by the engine control module (ECM). The best course of action is to use an OBD-II scanner to retrieve the specific trouble code(s) stored in the ECM. These codes can then be cross-referenced with the repair manual to determine the possible causes and appropriate diagnostic steps. It is recommended to address the underlying issue as soon as possible to prevent further damage to the vehicle.
How do I flush and refill the cooling system in a Mitsubishi Montero?
To flush and refill the cooling system in a Mitsubishi Montero, start by ensuring the engine is cool and the vehicle is parked on a level surface. Locate the radiator drain plug and place a drain pan underneath. Open the drain plug and allow the coolant to drain completely. Close the drain plug, and then remove the radiator cap and refill the system with a mixture of coolant and distilled water according to the manufacturer’s specifications. Run the engine with the heater turned on to purge any air bubbles, and recheck the coolant level after the engine has cooled down.
How do I replace a brake light bulb in a Mitsubishi Montero?
To replace a brake light bulb in a Mitsubishi Montero, open the rear hatch or trunk and locate the bulb holder behind the brake light lens. Twist the bulb holder counterclockwise to remove it from the lens assembly. Remove the old bulb from the holder and replace it with a new one, making sure it is securely in place. Reattach the bulb holder to the lens assembly by twisting it clockwise.
How do I replace a cabin air filter in a Mitsubishi Montero?
To replace a cabin air filter in a Mitsubishi Montero, locate the cabin air filter housing, which is typically located behind the glove compartment or under the dashboard on the passenger side. Remove any screws or clips securing the housing, and open it to access the old filter. Remove the old filter and replace it with a new one, ensuring it is properly aligned. Close the housing and secure it back in place.
How do I replace a cabin air filter in a Mitsubishi Montero?
To replace a cabin air filter in a Mitsubishi Montero, locate the cabin air filter housing, which is typically located behind the glove compartment or under the dashboard on the passenger side. Remove any screws or clips securing the housing, and open it to access the old filter. Remove the old filter and replace it with a new one, ensuring it is properly aligned. Close the housing and secure it back in place.
How do I replace a fuel filter in a Mitsubishi Montero?
To replace a fuel filter in a Mitsubishi Montero, start by relieving the fuel pressure by removing the fuel pump relay or fuse and running the engine until it stalls. Locate the fuel filter, which is typically located along the fuel line under the vehicle or inside the fuel tank. Use a wrench to disconnect the fuel lines from the filter, taking note of their orientation for reinstallation. Remove the old filter and install the new one, ensuring the fuel lines are securely connected. Reinstall the fuel pump relay or fuse, and start the engine to check for leaks.
How do I replace a headlight bulb in a Mitsubishi Montero?
To replace a headlight bulb in a Mitsubishi Montero, open the hood and locate the back of the headlight assembly. Depending on the model year, you may need to remove a dust cover or access panel. Disconnect the electrical connector from the bulb, and then twist the bulb socket counterclockwise to remove it. Replace the old bulb with a new one, making sure it is securely in place, and reconnect the electrical connector.
How do I replace a serpentine belt in a Mitsubishi Montero?
To replace a serpentine belt in a Mitsubishi Montero, locate the belt tensioner and use a wrench or socket to rotate it counterclockwise. This will release tension on the belt, allowing you to slip it off the pulleys. Pay close attention to the belt routing before removing it. Install the new belt by following the correct routing and using the tensioner to create the necessary tension. Double-check that the belt is properly seated on all pulleys.
How do I replace a windshield wiper blade in a Mitsubishi Montero?
To replace a windshield wiper blade in a Mitsubishi Montero, lift the wiper arm away from the windshield and locate the release tab or button on the wiper blade. Press or push the tab/button, and then slide the blade off the wiper arm. Align the new wiper blade with the arm’s hook or attachment point, and slide it until it clicks into place. Gently lower the wiper arm back onto the windshield.
How do I reset the maintenance light on a Mitsubishi Montero?
To reset the maintenance light on a Mitsubishi Montero, turn the ignition switch to the “ON” position without starting the engine. Press the trip meter reset button repeatedly until the “MAINT REQD” or “Maintenance Required” message appears on the display. Press and hold the trip meter reset button until the message starts to flash. Release the button, and the maintenance light should be reset.
How often should I change the air filter in a Mitsubishi Montero?
The air filter in a Mitsubishi Montero should be inspected and replaced as necessary every 12,000 to 15,000 miles or as recommended by the manufacturer. A clogged or dirty air filter can restrict airflow to the engine, resulting in reduced performance and fuel efficiency. Regular air filter maintenance helps to keep the engine running smoothly and prolong its lifespan.
What type of oil should I use in a Mitsubishi Montero?
The recommended oil for a Mitsubishi Montero depends on the engine type and model year. Consult the owner’s manual or the specifications section of the Mitsubishi Montero automotive repair manual for the specific oil type and viscosity grade. It is important to use the correct oil to ensure optimal engine performance and longevity.