Symptoms of P0670 OBD II Trouble Code
- Batteries - Check the batteries for a full charge. The compressed air in the cylinders only retains its heat for a faction of a second so the engine must turn over rapidly
- Glow Plug Relay - Appears similar to a remote starter relay and is usually located next to the starter relay. The two are not interchangeable because the glow plug relay - by design - handles much higher amperage
- Oil Temperature Sensor - This is used by the PCM to sense when and how long to operate the glow plugs
- Glow Plug Fuse - The ignition switch supplies the power to the glow plug relay while the PCM computer supplies the ground to actuate it, or in the case of a module, it will supply the ground
- Glow Plug Control Module or PCM
Common Causes of P0670 OBD II Trouble Code
- Start with checking for a fully charged battery
- Check the wiring for defects
- Using a voltmeter, check for battery voltage to the glow plug relay main supply terminal. Have a helper turn the key on and check the opposite terminal for voltage drop. If there is a drop over a half-volt replace the relay. The relay is the main cause of failure under this code
- Check for power from the ignition switch to the relay with the key on
- Check for relay actuation by disconnecting the oil temperature sensor and turning on the key. It will click when activated. Remove the ground on the small relay terminal and jumper it to ground. If it works now there is a problem with the module or PCM
- Check the glow plugs for an open circuit. Pull the connector off the glow plugs. Use a test light and connect it to the positive battery terminal. Touch each terminal to a glow plug. Each should show a good ground. They can also be tested with an ohmmeter. Each should have less than .4-ohms, or very low resistance.