AvtoVAZ VAZ-2114 Workshop Manuals and Repair Manuals

To check the transmission fluid level on your AvtoVAZ VAZ-2114, first make sure the vehicle is on a level surface and the engine is running. Locate the transmission dipstick, which is usually near the back of the engine compartment. Pull out the dipstick, wipe it clean, reinsert it, and then pull it out again. The fluid level should be between the "Full" and "Add" marks on the dipstick.

To replace the air filter in your AvtoVAZ VAZ-2114, first locate the air filter housing under the hood. Remove the clips or screws holding the housing in place, and then remove the old air filter. Install the new air filter, making sure it is seated correctly, and then replace the housing and clips/screws.

To replace the alternator in your AvtoVAZ VAZ-2114, first remove the negative battery cable. Locate the alternator, which is usually near the front of the engine, and remove the bolts holding it in place. Disconnect the electrical connections to the alternator, and then remove it from the vehicle. Install the new alternator, making sure it is securely in place, and then reconnect the electrical connections and negative battery cable.

To replace the battery in your AvtoVAZ VAZ-2114, first locate the battery under the hood or in the trunk. Disconnect the negative cable first, then the positive cable, and then remove the battery from the vehicle. Install the new battery, making sure it is securely in place, and then reconnect the positive cable first, then the negative cable.

To replace the brake pads on your AvtoVAZ VAZ-2114, first remove the wheel and locate the brake caliper. Remove the bolts holding the caliper in place, and then remove the old brake pads. Install the new brake pads, making sure they are seated correctly, and then reattach the caliper and wheel.

To replace the fuel filter in your AvtoVAZ VAZ-2114, first locate the fuel filter, which is usually under the vehicle near the fuel tank. Disconnect the fuel lines from the filter, and then remove the old filter from the vehicle. Install the new filter, making sure it is securely in place, and then reconnect the fuel lines.

To replace the oxygen sensor in your AvtoVAZ VAZ-2114, first locate the sensor, which is usually near the exhaust manifold. Disconnect the electrical connection to the sensor, and then use an oxygen sensor socket to remove the old sensor. Install the new sensor, making sure it is tightened to the correct torque, and then reconnect the electrical connection.

To replace the power steering pump in your AvtoVAZ VAZ-2114, first remove the negative battery cable. Locate the power steering pump, which is usually near the front of the engine, and remove the bolts holding it in place. Disconnect the hoses and electrical connections to the pump, and then remove it from the vehicle. Install the new pump, making sure it is securely in place, and then reconnect the hoses and electrical connections. Reconnect the negative battery cable.

To replace the radiator in your AvtoVAZ VAZ-2114, first drain the coolant from the radiator and engine block. Remove the bolts holding the radiator in place, and then disconnect the hoses and electrical connections to the radiator. Remove the old radiator from the vehicle, and then install the new radiator, making sure it is securely in place. Reconnect the hoses and electrical connections, and then refill the coolant.

To replace the serpentine belt in your AvtoVAZ VAZ-2114, first locate the belt routing diagram under the hood. Use a wrench to release the tension on the belt tensioner, and then slide the old belt off the pulleys. Install the new belt, following the belt routing diagram, and then release the tensioner to apply tension to the new belt.

To replace the spark plugs on your AvtoVAZ VAZ-2114, first locate the spark plug wires and follow them to the spark plugs. Remove the wire from the old spark plug, and then use a spark plug socket to remove the old spark plug. Install the new spark plug, making sure it is tightened to the correct torque, and then reattach the spark plug wire.

To replace the thermostat in your AvtoVAZ VAZ-2114, first locate the thermostat housing, which is usually near the top of the engine. Remove the bolts holding the housing in place, and then remove the old thermostat. Install the new thermostat, making sure it is seated correctly, and then replace the housing and bolts.

To replace the water pump in your AvtoVAZ VAZ-2114, first drain the coolant from the radiator and engine block. Locate the water pump, which is usually near the front of the engine, and remove the bolts holding it in place. Disconnect the hoses and electrical connections to the water pump, and then remove it from the vehicle. Install the new water pump, making sure it is securely in place, and then reconnect the hoses and electrical connections. Refill the coolant.

To replace the wheel bearings on your AvtoVAZ VAZ-2114, first remove the wheel and brake caliper. Remove the dust cap and cotter pin from the spindle, and then remove the spindle nut. Remove the hub assembly from the spindle, and then remove the old wheel bearings. Install the new wheel bearings, making sure they are seated correctly, and then reassemble the hub assembly and spindle. Reinstall the wheel and brake caliper.

The recommended oil type for your AvtoVAZ VAZ-2114 is 5W-30 synthetic oil. This oil type provides excellent protection for your engine in a variety of temperatures and driving conditions. Always check your owner's manual for the recommended oil type and change intervals.