Chery Fora A21 Workshop Manuals and Repair Manuals

To bleed the brake system on Chery Fora A21, start with the brake farthest from the master cylinder and have an assistant pump the brake pedal while you open the bleeder valve. Repeat this process for each brake until all air is removed from the system. Make sure to check the brake fluid level regularly during the process.

Changing brake pads on Chery Fora A21 requires removing the wheel, unbolt the caliper, remove the old brake pad, and replace it with a new one. Reinstall the caliper and wheel. Make sure to bed in the new brake pads properly to ensure proper braking performance.

To check the transmission fluid level on Chery Fora A21, start the engine and let it idle for a few minutes. Then, remove the dipstick, wipe it clean, reinsert it, and then remove it again to check the fluid level. The fluid level should be between the two marks on the dipstick.

A misfiring engine on Chery Fora A21 can be caused by several factors, including a faulty spark plug, a clogged fuel injector, a damaged ignition coil, or a vacuum leak. Check each of these components to diagnose the issue, and replace or repair as necessary.

A rough idle on Chery Fora A21 can be caused by several factors, including a dirty air filter, a faulty oxygen sensor, a clogged fuel filter, or a vacuum leak. Check each of these components to diagnose the issue, and replace or repair as necessary.

Replacing the air filter on Chery Fora A21 requires removing the air filter housing cover, taking out the old filter, and installing a new one. Make sure the new filter is properly seated in the housing, and then reinstall the cover.

Replacing the alternator on Chery Fora A21 requires disconnecting the battery, removing the drive belt, disconnecting the electrical connections, and then removing the mounting bolts. Install the new alternator, reconnect the electrical connections, reinstall the drive belt, and then reconnect the battery.

To replace the battery on Chery Fora A21, turn off the engine, remove the negative cable, remove the positive cable, and then remove the battery hold-down bracket. Lift out the old battery and install the new one, making sure it is properly secured. Reconnect the cables, starting with the positive cable and then the negative cable.

Replacing the fuel filter on Chery Fora A21 requires locating the filter, disconnecting the fuel lines, and then removing the old filter. Install the new filter, making sure the fuel lines are securely connected, and then start the engine to check for proper operation.

Replacing the serpentine belt on Chery Fora A21 requires locating the tensioner, using a wrench to loosen the tensioner, and then removing the old belt. Install the new belt, making sure it is routed properly, and then use the wrench to tighten the tensioner.

Replacing the spark plugs on Chery Fora A21 requires removing the ignition coil, using a spark plug socket to remove the old spark plug, gapping the new spark plug, and then installing the new spark plug. Make sure the ignition coil is properly seated, and then repeat the process for the other spark plugs.

Replacing the timing belt on Chery Fora A21 requires removing the engine covers, loosening the tensioner, and then removing the old timing belt. Install the new timing belt, making sure it is properly tensioned, and then reinstall the engine covers.

A no-start condition on Chery Fora A21 can be caused by several factors, including a dead battery, a faulty starter motor, a clogged fuel filter, or a faulty ignition switch. Check each of these components to diagnose the issue, and replace or repair as necessary.

An overheating engine on Chery Fora A21 can be caused by several factors, including a low coolant level, a malfunctioning thermostat, a damaged water pump, or a clogged radiator. Check each of these components to diagnose the issue, and replace or repair as necessary.

The recommended engine oil for Chery Fora A21 is 5W-30. It should be a high-quality synthetic blend oil that meets API SN standards. The engine oil should be changed every 5,000 miles or as recommended in the owner's manual.