Daihatsu Terios II Workshop Manuals and Repair Manuals

To adjust the clutch, first locate the clutch cable adjustment nut. Loosen the locknut and turn the adjustment nut until the clutch pedal has the desired amount of free play. Tighten the locknut to secure the adjustment.

To change the oil, locate the oil pan underneath the vehicle and remove the drain plug. Allow the old oil to drain completely before replacing the plug and adding new oil according to the manufacturer's specifications. It is recommended to also replace the oil filter during an oil change.

To check the engine coolant level, the engine must be cool. Locate the coolant reservoir and check the level against the markings on the reservoir. If the level is low, add a mixture of water and coolant according to the manufacturer's recommendations.

To check the transmission fluid level, the engine must be running and the vehicle should be on a level surface. Locate the transmission dipstick, remove it, wipe it clean, and reinsert it. Remove the dipstick again and check the fluid level. Add more fluid if necessary.

To replace a battery, first disconnect the negative cable and then the positive cable. Remove the battery hold-down clamp and lift the battery out of the vehicle. Replace it with a new battery, reconnecting the cables in reverse order.

To replace a brake pad, first remove the wheel and then remove the caliper. Remove the old brake pad and replace it with a new one. Reassemble the caliper and wheel, and make sure to properly bed the new brake pad according to the manufacturer's recommendations.

To replace a cabin air filter, locate the filter housing, which is usually located behind the glove box. Remove the housing cover and take out the old filter. Replace it with a new filter and reattach the cover.

To replace a fuel filter, first locate the filter housing, which is usually located near the fuel tank. Remove the old filter and replace it with a new one. Make sure to properly prime the new filter before starting the engine.

To replace a headlight bulb, first locate the back of the headlight assembly. Twist the bulb socket counterclockwise and remove it from the assembly. Remove the old bulb and replace it with a new one. Reinsert the socket and twist it clockwise to secure it in place.

To replace a serpentine belt, locate the tensioner pulley and use a wrench to rotate it counterclockwise. Remove the old belt and replace it with a new one, following the correct routing pattern. Release the tensioner pulley to put tension on the new belt.

To replace a spark plug, first remove the engine cover and locate the spark plug. Use a spark plug socket and ratchet to remove the old spark plug. Replace it with a new spark plug, making sure to properly torque it to the manufacturer's specifications. Reattach the engine cover.

To replace a starter, first disconnect the battery cables. Locate the starter and remove the bolts holding it in place. Disconnect the electrical connections and remove the starter. Replace it with a new starter and reattach the bolts and electrical connections. Reconnect the battery cables.

To replace a thermostat, first drain the coolant from the engine. Remove the housing that holds the thermostat and remove the old thermostat. Replace it with a new thermostat and reattach the housing. Refill the engine with coolant.

The recommended tire pressure for the Daihatsu Terios II is 32 psi for the front tires and 29 psi for the rear tires. It is important to check tire pressure regularly and adjust accordingly for optimal performance and safety. Consult the owner's manual for specific recommendations.

The recommended gasoline for the Daihatsu Terios II is unleaded with an octane rating of 91 or higher. Using a lower octane rating can cause damage to the engine and decrease performance. Always consult the owner's manual for specific recommendations.