Ford Expedition Workshop Manuals and Repair Manuals

Every Manual available online - found by our community and shared for FREE. Enjoy!

Ford Expedition

Introduced in 1996 to replace the Ford Bronco, the Ford Expedition is five-door, full-size SUV from American automaker Ford Motor Company. Available with rear-wheel or four-wheel drive and a seating capacity of up to nine, the Expedition is a popular choice among the consumers. Based on Ford F-150 trucks, this is the largest SUV from Ford. The expedition also has a towing capacity of 4.6 tons. A special limited edition Ford Expedition with Funkmaster Flex "FMF" trim and logos was offered for the 2008 model year only. Only 650 were produced and each are individually numbered on the center console.

Ford Expedition FAQ's

How do I change the air filter on a Ford Expedition?

To change the air filter on a Ford Expedition, locate the air filter housing and remove the cover. Then, remove the old air filter and replace it with a new one. Make sure the new air filter is properly installed and the cover is securely fastened. Regular air filter changes can help maintain engine performance and fuel efficiency.

How do I change the cabin air filter on a Ford Expedition?

To change the cabin air filter on a Ford Expedition, locate the cabin air filter housing, which is typically behind the glove box. Remove the old filter and replace it with a new one. Regular cabin air filter changes can help improve air quality inside the vehicle.

How do I change the spark plugs on a Ford Expedition?

To change the spark plugs on a Ford Expedition, locate the spark plug wires and disconnect them from the spark plugs. Use a spark plug socket and extension to remove the old spark plugs and replace them with new ones. Reconnect the spark plug wires, making sure each wire is connected to the correct spark plug. Regular spark plug changes can help maintain engine performance and fuel efficiency.

How do I check the transmission fluid level on a Ford Expedition?

To check the transmission fluid level on a Ford Expedition, start the engine and let it run for a few minutes. Then, locate the transmission dipstick, remove it, and wipe it clean. Reinsert the dipstick and remove it again to check the fluid level. If the fluid level is low, add the recommended transmission fluid until it reaches the proper level.

How do I diagnose an engine misfire on a Ford Expedition?

To diagnose an engine misfire on a Ford Expedition, start by checking the spark plugs and ignition coils. Make sure they are properly functioning and replace any that are worn or damaged. If the issue persists, check the fuel injectors and consider having the engine computer system diagnosed by a professional. A misfiring engine can cause damage to the catalytic converter and other engine components, so it is important to address the issue as soon as possible.

How do I replace a battery on a Ford Expedition?

To replace a battery on a Ford Expedition, locate the battery and disconnect the negative cable first, then the positive cable. Remove the battery hold-down clamp and lift the battery out of the vehicle. Replace the old battery with a new one and reconnect the positive cable first, then the negative cable. It is important to properly dispose of the old battery and to use caution when handling batteries.

How do I replace a fuse on a Ford Expedition?

To replace a fuse on a Ford Expedition, locate the fuse panel, which is typically located under the dashboard or in the engine compartment. Find the fuse that needs to be replaced and use the fuse puller tool to remove it. Replace the old fuse with a new one of the same amperage rating. It is important to replace fuses as soon as they burn out to prevent electrical issues.

How do I replace a headlight bulb on a Ford Expedition?

To replace a headlight bulb on a Ford Expedition, locate the headlight assembly and remove the cover. Then, remove the old bulb and replace it with a new one. Make sure the new bulb is properly installed and the cover is securely fastened. It is important to replace headlight bulbs as soon as they burn out to maintain proper visibility while driving.

How do I replace a serpentine belt on a Ford Expedition?

To replace a serpentine belt on a Ford Expedition, locate the belt tensioner and use a wrench or socket to release tension on the belt. Remove the old belt and replace it with a new one, making sure it is properly routed around all the pulleys. Release the tensioner to apply tension to the new belt. A worn or damaged serpentine belt can cause engine performance issues, so it is important to replace it as soon as it shows signs of wear.

How do I reset the oil change light on a Ford Expedition?

To reset the oil change light on a Ford Expedition, turn the ignition to the "on" position without starting the engine. Press the gas pedal three times within five seconds. The oil change light should flash, indicating that it has been reset. It is important to reset the oil change light after each oil change to ensure accurate maintenance records.

How often should I replace the brake pads on a Ford Expedition?

The frequency of brake pad replacement on a Ford Expedition can vary depending on driving habits and conditions. Generally, brake pads should be replaced every 30,000 to 70,000 miles. It is important to have your brakes inspected regularly to ensure they are in good working condition.

What is the recommended coolant for a Ford Expedition?

Ford recommends using Motorcraft Premium Gold Engine Coolant or a similar ethylene glycol-based coolant for the Ford Expedition. It is important to use the recommended coolant to ensure proper engine cooling and prevent damage to the cooling system. Always mix the coolant with distilled water in the recommended ratio.

What is the recommended oil type for a Ford Expedition?

Ford recommends using synthetic blend 5W-20 or 5W-30 motor oil for the Ford Expedition. Using the recommended oil type will help protect the engine and ensure it runs smoothly. It is important to change the oil at the recommended intervals, usually every 5,000 miles, to maintain the health of the engine.

What is the recommended tire pressure for a Ford Expedition?

The recommended tire pressure for a Ford Expedition is typically 35 psi. However, it is important to consult the owner's manual or the tire information placard on the vehicle to confirm the recommended tire pressure for your specific model. Maintaining the correct tire pressure can help improve handling, fuel efficiency, and tire life.

What is the towing capacity of a Ford Expedition?

The towing capacity of a Ford Expedition varies depending on the model and equipment. The maximum towing capacity for a properly equipped Expedition can range from 6,000 to 9,300 pounds. It is important to consult the owner's manual or a dealership to determine the specific towing capacity for your vehicle.

Ford Expedition Manuals Index

Ford Expedition Workshop Manual

Ford Expedition Owners Manual

Ford Expedition Misc Document

Related Models

Ford Expedition on Amazon

Ford Pickups, Expedition, Lincoln Nav 2WD & 4WD Gas F-150 (97-03), F-150 Heritage (04), F-250 (97-99), Expedition (97-17), Navigator (98-17) Haynes ... Includes Lincoln Navigator and F-150 Heritage