Infiniti M35 Workshop Manuals and Repair Manuals

To change the windshield wipers on an Infiniti M35, lift the wiper arm away from the windshield and locate the small tab or button on the wiper blade. Press or slide this tab to release the blade from the wiper arm. Attach the new wiper blade by aligning the adapter with the wiper arm and firmly pressing it into place. Repeat the process for the other wiper blade.

To check the brake fluid level in an Infiniti M35, locate the brake fluid reservoir under the hood, typically near the firewall. The reservoir is transparent, allowing you to easily see the fluid level. Ensure the vehicle is on a level surface, remove the cap, and visually inspect the fluid level. If necessary, add brake fluid to the designated "MAX" line, using the recommended type as stated in the owner's manual.

To check the power steering fluid level in an Infiniti M35, locate the power steering fluid reservoir, which is typically near the engine and labeled accordingly. Ensure the vehicle is on a level surface and the engine is off. Remove the cap from the reservoir, and visually inspect the fluid level, which should be between the "MIN" and "MAX" markings. If necessary, add the recommended power steering fluid to reach the appropriate level.

To check the tire pressure in an Infiniti M35, start by ensuring the tires are cold. Remove the valve cap from each tire, then use a tire pressure gauge to measure the pressure by pressing it onto the valve stem. Compare the measured pressure to the recommended tire pressure listed on the driver's side door jamb or in the owner's manual.

To jump-start an Infiniti M35, start by parking the assisting vehicle close enough to reach the battery terminals with jumper cables. Turn off all electrical accessories in both vehicles. Connect the positive (red) jumper cable clamp to the positive terminal of the dead battery. Attach the other end of the positive cable to the positive terminal of the assisting vehicle's battery. Connect the negative (black) cable clamp to the negative terminal of the assisting vehicle's battery, then attach the other end to a metal, unpainted surface of the dead vehicle's engine block. Start the assisting vehicle's engine, then attempt to start the Infiniti M35. Once started, carefully disconnect the jumper cables in the reverse order.

To replace a fuse in an Infiniti M35, start by locating the fuse box, usually found in the engine compartment or the passenger compartment. Open the fuse box cover and locate the fuse corresponding to the affected component. Use the fuse puller tool or a pair of needle-nose pliers to carefully remove the fuse, then insert a new fuse of the same amperage rating into the appropriate slot. Close the fuse box cover securely.

To replace a headlight bulb in an Infiniti M35, start by opening the hood and locating the back of the headlight assembly. Remove the electrical connector from the bulb, then twist and remove the bulb from the assembly. Install the new bulb by reversing these steps, ensuring it is securely in place. It is recommended to consult the owner's manual for specific instructions and bulb types.

To replace the battery in an Infiniti M35 key fob, start by prying open the back cover using a small flathead screwdriver. Remove the old battery and insert a new CR2025 battery, ensuring the correct polarity. Close the back cover firmly until it clicks into place. It is recommended to consult the owner's manual for specific instructions and illustrations.

To reset the maintenance light in an Infiniti M35, turn the ignition key to the "ON" position without starting the engine. Press the trip odometer button until the maintenance reminder is displayed, then hold the button for approximately 10 seconds until the light resets. The maintenance light should turn off, indicating a successful reset.

The air filter in an Infiniti M35 should be replaced every 15,000 to 30,000 miles, or as recommended by the manufacturer. A clogged or dirty air filter can restrict airflow to the engine, leading to reduced performance and fuel efficiency. Regular replacement of the air filter helps ensure proper engine function and prolongs its lifespan.

The oil in an Infiniti M35 should be changed every 5,000 to 7,500 miles, or approximately every 6 months, whichever comes first. Regular oil changes help maintain engine performance and prevent damage caused by old or contaminated oil. It is important to follow the recommended oil change intervals stated in the owner's manual.

The transmission fluid in an Infiniti M35 should be changed every 60,000 to 90,000 miles, or as recommended by the manufacturer. Regular transmission fluid changes help maintain smooth shifting and prevent premature wear or damage to the transmission. It is important to follow the recommended maintenance schedule to ensure optimal performance and longevity of the transmission.

The recommended coolant for an Infiniti M35 is a genuine Nissan Long Life Antifreeze/Coolant or an equivalent high-quality ethylene glycol-based coolant. This coolant provides effective engine cooling and corrosion protection. It is important to use the recommended coolant type and maintain the proper coolant level to prevent overheating and engine damage.

The recommended oil type for an Infiniti M35 is fully synthetic 5W-30 oil. This type of oil provides optimal engine performance and protection, especially in extreme temperatures. It is important to use the recommended oil type to ensure the longevity and efficiency of the engine.