Mazda Millenia Workshop Manuals and Repair Manuals

Every Manual available online - found by our community and shared for FREE. Enjoy!

Mazda Millenia

The Mazda Millenia is an automobile which was manufactured by Mazda in Japan from 1993 to 2003. The Millenia was released in the autumn of 1993 in Europe as the Mazda Xedos 9 and in Japan and Australia as the Eunos 800. The Mazda Xedos 9 was a luxury car for Mazda of Europe. Sold between 1993 and 2002, the Xedos 9 was the export version of Mazda's upscale Eunos 800 on the Mazda T platform. Mazda Motorsport Australia released a limited edition Eunos 800M SP with improved suspension and larger alloy wheel and tyre combination, but with no modifications to the engine.

Mazda Millenia FAQ's

How do I adjust the headlights on a Mazda Millenia?

To adjust the headlights on a Mazda Millenia, park the vehicle on a level surface facing a wall or garage door. Using a screwdriver or a specific headlight adjustment tool, locate the vertical and horizontal adjustment screws on the back of the headlight assembly. Turn the screws clockwise or counterclockwise to adjust the beam height and alignment. Aim the headlights so that the center of the light beam is just below the level of the headlights on the vehicle.

How do I change the oil in a Mazda Millenia?

To change the oil in a Mazda Millenia, you will need to locate the oil drain plug underneath the engine and remove it to let the old oil drain out. Once all the old oil has been drained, replace the drain plug and remove the oil filter. Install a new oil filter and fill the engine with the recommended amount of fresh oil, making sure to check the oil level using the dipstick.

How do I change the serpentine belt in a Mazda Millenia?

To change the serpentine belt in a Mazda Millenia, locate the belt tensioner pulley and use a wrench or socket to relieve the tension on the belt. Slide the belt off the pulleys and carefully release the tensioner. Route the new belt around the pulleys according to the belt routing diagram, ensuring it is properly seated on each pulley. Finally, use the tensioner to apply tension to the belt and double-check its alignment.

How do I replace a headlight bulb in a Mazda Millenia?

To replace a headlight bulb in a Mazda Millenia, open the hood and locate the back of the headlight assembly. Depending on the specific model year, you may need to remove a dust cover or unplug the electrical connector. Twist the bulb socket counterclockwise and carefully remove the old bulb. Insert the new bulb, making sure not to touch the glass part. Reconnect the electrical connector and secure the dust cover if applicable.

How do I replace the air filter in a Mazda Millenia?

To replace the air filter in a Mazda Millenia, locate the air filter housing, which is usually located near the engine. Open the housing by removing any clips or screws, and carefully take out the old air filter. Inspect the housing for any debris or dirt and clean it if necessary. Install the new air filter, making sure it is properly seated and secured. Close the housing and ensure all fasteners are tightened.

How do I replace the brake pads on a Mazda Millenia?

To replace the brake pads on a Mazda Millenia, start by loosening the lug nuts on the wheel and raising the vehicle using a jack. Remove the wheel to gain access to the brake caliper. Use a wrench or socket to remove the caliper bolts and carefully remove the caliper from the rotor. Take out the old brake pads and install the new ones, making sure they are positioned correctly. Reassemble the caliper, replace the wheel, and tighten the lug nuts.

How do I replace the cabin air filter in a Mazda Millenia?

To replace the cabin air filter in a Mazda Millenia, locate the cabin air filter housing, which is usually located behind the glove box. Remove the glove box by releasing the retaining clips or screws. Once the glove box is out, locate the cabin air filter housing cover and remove it. Take out the old cabin air filter and install the new one, making sure it is properly seated. Reassemble the housing cover and glove box.

How do I replace the fuel filter in a Mazda Millenia?

To replace the fuel filter in a Mazda Millenia, start by relieving the fuel pressure by disconnecting the fuel pump relay or fuse and allowing the engine to run until it stalls. Locate the fuel filter, which is typically mounted on the frame near the fuel tank. Use a wrench or socket to remove the fittings on each end of the filter. Install the new filter in the correct direction, making sure the arrows on the filter match the fuel flow direction. Tighten the fittings and reconnect the fuel pump relay or fuse.

How do I replace the spark plugs in a Mazda Millenia?

To replace the spark plugs in a Mazda Millenia, locate the spark plug wires or coil packs on the engine. Carefully remove the wires or coil packs to expose the spark plugs. Use a spark plug socket and ratchet to remove the old spark plugs. Inspect the new spark plugs for any damage or defects, and then install them by hand, followed by a final tightening with the socket and ratchet. Reattach the spark plug wires or coil packs.

How do I reset the check engine light on a Mazda Millenia?

To reset the check engine light on a Mazda Millenia, you can disconnect the battery for a few minutes, which will clear the fault codes stored in the engine control unit (ECU). Alternatively, you can use an OBD-II scanner to clear the codes. It is important to note that resetting the check engine light without addressing the underlying issue may result in the light reappearing.

How do I troubleshoot a non-starting Mazda Millenia?

When troubleshooting a non-starting Mazda Millenia, start by checking the battery voltage and connections to ensure they are in good condition. If the battery is fine, check the fuel level and listen for the fuel pump priming when turning the ignition on. Inspect the ignition system for any loose or damaged connections. If these steps don't solve the issue, it is recommended to consult a professional mechanic or refer to the Mazda Millenia repair manual for further diagnosis.

What are the recommended tire pressures for a Mazda Millenia?

The recommended tire pressures for a Mazda Millenia can be found in the owner's manual or on a sticker located on the driver's side door jamb. Typically, the recommended tire pressures range from 30 to 35 psi. It is important to regularly check and maintain the proper tire pressure to ensure optimal handling, fuel efficiency, and tire longevity.

What is the recommended coolant for a Mazda Millenia?

The recommended coolant for a Mazda Millenia is a mixture of ethylene glycol-based coolant and distilled water, preferably in a 50:50 ratio. This coolant mixture provides the necessary protection against freezing and boiling, as well as corrosion prevention for the engine's cooling system. It is important to only use the recommended coolant to maintain the proper functioning of the cooling system.

What is the recommended interval for changing the timing belt on a Mazda Millenia?

The recommended interval for changing the timing belt on a Mazda Millenia varies depending on the model year and engine type. It is crucial to consult the owner's manual or contact a Mazda dealership to determine the specific interval for your vehicle. Timing belt failure can cause severe engine damage, so it is important to adhere to the recommended replacement schedule.

What is the recommended transmission fluid for a Mazda Millenia?

The recommended transmission fluid for a Mazda Millenia varies depending on the model year and transmission type. It is crucial to consult the owner's manual or contact a Mazda dealership to determine the correct transmission fluid for your specific vehicle. Using the wrong type of fluid can lead to transmission damage and potential failure.

Mazda Millenia Manuals Index

Mazda Millenia Workshop Manual

Mazda Millenia Owners Manual

Mazda Millenia Misc Document

Related Models

Mazda Millenia on Amazon

Mazda 323/MX-3/626/MX-6/Millenia/Protege (90 - 98) (Chilton) (Chilton's Total Car Care Repair Manual)