Oldsmobile Toronado Workshop Manuals and Repair Manuals
Every Manual available online - found by our community and shared for FREE. Enjoy!
Oldsmobile Toronado
The Oldsmobile Toronado, produced from 1966 to 1992 by Oldsmobile division of General Motorswas a 2- door coupe and the first front wheel drive automobile produced in the USA. It was designed to be a full-size personal luxury car to compete with the Ford Thunderbird. In terms of structure, the Toronado had a resemblance to the Buick Riviera and the Cadillac Eldorado with the E-body design. The original Toronado began as a design painting by Oldsmobile stylist David North in 1962. His design, dubbed the "Flame Red Car", was for a compact sports/personal car never intended for production. A few weeks after the design was finished, however, Oldsmobile division was informed it would be permitted to build a personal car in the Riviera/Thunderbird class for the 1966 model year, and North's design was selected.Oldsmobile Toronado FAQ's
How can I troubleshoot a starting issue with my Oldsmobile Toronado?
If your Oldsmobile Toronado is experiencing starting issues, start by checking the battery connections for any corrosion or loose connections. Ensure the battery is fully charged and try jump-starting the vehicle if needed. If the battery and connections are in good condition, check the starter motor and ignition system for any faults or malfunctions. If the issue persists, consulting the Oldsmobile Toronado automotive repair manual for detailed troubleshooting steps would be beneficial.
How do I bleed the brakes in my Oldsmobile Toronado?
To bleed the brakes in your Oldsmobile Toronado, start with the wheel furthest from the master cylinder (usually the rear passenger side) and work your way towards the closest (usually the front driver side). Begin by loosening the bleeder screw with a wrench, then have someone press the brake pedal down and hold it. Once the pedal is depressed, tighten the bleeder screw to prevent air from entering the system. Repeat this process multiple times, checking the brake fluid level regularly, until all air bubbles are eliminated and the brake pedal feels firm.
How do I change the engine oil in my Oldsmobile Toronado?
To change the engine oil in your Oldsmobile Toronado, first locate the oil drain plug underneath the engine. Use a wrench to loosen and remove the drain plug, allowing the old oil to drain into a suitable container. Once the oil has completely drained, replace the drain plug and proceed to remove the old oil filter, making sure to lubricate the rubber gasket of the new filter before installing it. Finally, refill the engine with the recommended amount and type of fresh oil, ensuring it is at the correct level on the dipstick.
How do I check and adjust the tire pressure in my Oldsmobile Toronado?
To check and adjust the tire pressure in your Oldsmobile Toronado, start by locating the tire pressure placard, typically found on the driver's side door jamb or inside the fuel filler door. Using a tire pressure gauge, check the pressure of each tire, including the spare if applicable. If the pressure is too low, add air until it reaches the recommended level. If the pressure is too high, release some air using the tire valve. It is important to check the tire pressure regularly, especially before long trips, as correct tire pressure contributes to better fuel efficiency, tire longevity, and overall safety.
How do I properly jump-start my Oldsmobile Toronado?
To properly jump-start your Oldsmobile Toronado, start by positioning the assisting vehicle with a fully charged battery close enough to connect jumper cables. Ensure both vehicles are turned off and the parking brakes are engaged. Connect the positive (red) jumper cable clamp to the positive terminal of the dead battery, then connect the other end of the positive cable to the positive terminal of the assisting vehicle's battery. Next, connect the negative (black) jumper cable clamp to the negative terminal of the assisting vehicle's battery, and the other end to a grounded metal surface on the dead vehicle. Start the assisting vehicle and let it run for a few minutes, then attempt to start the dead vehicle. Once the dead vehicle starts, remove the jumper cables in the reverse order they were connected.
How do I replace a cabin air filter in my Oldsmobile Toronado?
To replace a cabin air filter in your Oldsmobile Toronado, locate the cabin air filter housing, usually found behind the glove compartment or under the dashboard. Open the housing by releasing the clips or removing the screws, then slide out the old filter. Before installing the new filter, make sure it is the correct size and orientation. Slide the new filter into the housing, ensuring it is fully seated, and secure the housing back in place. Regularly replacing the cabin air filter helps maintain clean and fresh air inside the vehicle's cabin.
How do I replace a fuel filter in my Oldsmobile Toronado?
To replace a fuel filter in your Oldsmobile Toronado, start by locating the filter, which is typically found along the fuel line, either near the fuel tank or in the engine compartment. Before disconnecting any lines, relieve the fuel system pressure by removing the fuel pump fuse or relay and starting the engine until it stalls. Once the pressure is relieved, use a wrench or appropriate tool to loosen the fittings on both sides of the
How do I replace a headlight bulb in my Oldsmobile Toronado?
To replace a headlight bulb in your Oldsmobile Toronado, start by opening the hood and locating the back of the headlight assembly. Disconnect the electrical connector from the bulb by gently pressing the release tab and pulling it off. Next, twist the bulb counterclockwise to remove it from the assembly. Install the new bulb by twisting it clockwise until it locks in place, then reconnect the electrical connector. Finally, test the headlight to ensure it is functioning properly.
How do I replace a serpentine belt in my Oldsmobile Toronado?
To replace a serpentine belt in your Oldsmobile Toronado, start by locating the belt routing diagram, usually found on a decal under the hood or in the vehicle's owner's manual. Using a wrench or belt tensioner tool, release tension on the belt by rotating the tensioner in the appropriate direction. Once the tension is relieved, slide the old belt off the pulleys. Install the new belt following the proper routing, ensuring it is properly seated on each pulley. Finally, release the tensioner, allowing it to apply proper tension to the new belt.
How do I replace a windshield wiper blade in my Oldsmobile Toronado?
To replace a windshield wiper blade in your Oldsmobile Toronado, lift the wiper arm away from the windshield and locate the release tab or button on the wiper blade assembly. Press or release the tab/button, depending on the design, and slide the old blade out of the assembly. Align the new wiper blade with the assembly and push it in until it clicks into place. Gently lower the wiper arm back onto the windshield and repeat the process for the other wiper blade if necessary.
How do I reset the check engine light in my Oldsmobile Toronado?
To reset the check engine light in your Oldsmobile Toronado, you can disconnect the negative battery cable for a few minutes, which will clear the codes and reset the light. However, this method may also reset other settings and erase important data in your vehicle's computer system. As a more recommended approach, consider using an OBD-II scanner or code reader to diagnose the specific issue triggering the check engine light. Once the issue is resolved, the scanner can also be used to clear the codes and reset the light.
How often should I replace the air filter in my Oldsmobile Toronado?
It is recommended to replace the air filter in your Oldsmobile Toronado every 12,000 to 15,000 miles or as specified in your vehicle's owner's manual. However, if you drive in dusty or polluted environments more frequently, it's advisable to check and replace the air filter more often. A clogged air filter can restrict airflow to the engine, leading to reduced performance and potential damage to other engine components.
How often should I replace the spark plugs in my Oldsmobile Toronado?
The spark plugs in your Oldsmobile Toronado should be replaced every 30,000 miles or as recommended in your vehicle's owner's manual. Worn or faulty spark plugs can lead to misfires, reduced fuel efficiency, and poor engine performance. When replacing the spark plugs, ensure you use the correct type and gap specified by the manufacturer to maintain optimal engine operation.
What type of transmission fluid should I use in my Oldsmobile Toronado?
For an Oldsmobile Toronado equipped with an automatic transmission, it is recommended to use Dexron III or equivalent transmission fluid, as specified in the vehicle's owner's manual. Using the correct type and quality of transmission fluid is crucial for maintaining smooth shifting, proper lubrication, and overall transmission longevity. It is important to check the fluid level regularly and adhere to the manufacturer's recommendations for fluid changes.
Oldsmobile Toronado Manuals Index
Oldsmobile Toronado Workshop Manual
-
- Oldsmobile Toronado 1969 Workshop Manual
- (693 Pages)
- (Free)
-
- Oldsmobile Toronado 1971 Workshop Manual
- (648 Pages)
- (Free)
Oldsmobile Toronado Misc Document
- (Free)