Spyker C8 LAVIOLETTE SWB Workshop Manuals and Repair Manuals

Every Manual available online - found by our community and shared for FREE. Enjoy!

Spyker C8 LAVIOLETTE SWB

The Spyker C8 is a sports car produced by the Dutch automaker Spyker Cars. The C8 Spyder is the original base model with an Audi 4.2 litre V8 engine giving the car 400 PS and a top speed of 300 km/h. The C8 Laviolette has the 400 PS Audi engine but unlike the spyder models that come with a fixed roof with a glass canopy. The C8 Double 12R is a version made specifically for the 24 hours of Le Mans also using the Audi V8 engine with 480 PS and the C8 Double 12S is the street version of this car which has the same glass canopy of the Laviolette and optionally has a 620 PS engine instead of the 400 PS engine from the C8 spyder, giving it a top speed between 301 km/h and 345 km/h depending on the engine. Both Double 12 versions have a modified C8 spyder frame with a longer wheelbase and a bigger fuel tank, 100 litres instead of 75. Spyker C8 featured in the movies Basic Instinct 2 and War.

Spyker C8 LAVIOLETTE SWB FAQ's

How do I change a flat tire on a Spyker C8 LAVIOLETTE SWB?

To change a flat tire on a Spyker C8 LAVIOLETTE SWB, first, locate the spare tire, jack, and lug wrench. Park the vehicle on a flat and stable surface, engage the parking brake, and place wheel chocks if available. Use the lug wrench to loosen the lug nuts, but do not remove them completely. Position the jack under the vehicle at the designated lifting point and raise the vehicle until the flat tire is off the ground. Remove the lug nuts, then remove the flat tire. Install the spare tire, hand-tighten the lug nuts, lower the vehicle, and use the lug wrench to fully tighten the lug nuts in a diagonal pattern.

How do I change the oil in a Spyker C8 LAVIOLETTE SWB?

To change the oil in a Spyker C8 LAVIOLETTE SWB, start by locating the oil drain plug underneath the vehicle. Use a wrench to loosen and remove the drain plug, allowing the old oil to drain into a suitable container. After the oil has completely drained, replace the drain plug and proceed to refill the engine with the recommended amount and type of oil, as specified in the vehicle's manual.

How do I check and replace the air filter in a Spyker C8 LAVIOLETTE SWB?

To check and replace the air filter in a Spyker C8 LAVIOLETTE SWB, open the hood and locate the air filter housing. Unclip or unscrew the housing cover to reveal the air filter. Inspect the filter for any signs of damage or excessive dirt accumulation. If necessary, replace the old filter with a new one that matches the specifications outlined in the vehicle's manual. Make sure the filter is properly seated in the housing, then secure the cover back in place.

How do I check the brake fluid level in a Spyker C8 LAVIOLETTE SWB?

To check the brake fluid level in a Spyker C8 LAVIOLETTE SWB, locate the brake fluid reservoir, which is typically located on the driver's side of the engine compartment. The reservoir is transparent and has "MAX" and "MIN" markings indicating the acceptable fluid level range. Ensure the vehicle is on a level surface, then remove the reservoir cap. Check the fluid level against the markings and add the recommended brake fluid, if necessary, to maintain the level between the "MAX" and "MIN" lines. Be cautious not to spill brake fluid on any painted surfaces, as it can cause damage.

How do I check the transmission fluid level in a Spyker C8 LAVIOLETTE SWB?

To check the transmission fluid level in a Spyker C8 LAVIOLETTE SWB, start the engine and allow it to reach normal operating temperature. Locate the transmission dipstick, which is typically labeled and located near the back of the engine bay. Remove the dipstick, wipe it clean, reinsert it fully, and then remove it again. Check the fluid level indicated on the dipstick against the "Full" and "Add" or "Min" markings. Add the recommended transmission fluid, if necessary, to bring the level within the acceptable range. It is important to use the correct type of transmission fluid as specified in the vehicle's manual.

How do I jump-start a Spyker C8 LAVIOLETTE SWB?

To jump-start a Spyker C8 LAVIOLETTE SWB, you will need a set of jumper cables and another vehicle with a fully charged battery. Park the vehicles close enough for the jumper cables to reach both batteries. Connect one end of the positive cable (usually red) to the positive terminal of the dead battery, then connect the other end to the positive terminal of the charged battery. Next, connect one end of the negative cable (usually black) to the negative terminal of the charged battery and the other end to a metal surface on the engine block of the dead vehicle. Start the engine of the charged vehicle and let it run for a few minutes, then attempt to start the engine of the dead vehicle. Once the dead vehicle starts, carefully remove the jumper cables in the reverse order of connection.

How do I replace a fuse in a Spyker C8 LAVIOLETTE SWB?

To replace a fuse in a Spyker C8 LAVIOLETTE SWB, locate the vehicle's fuse box, which is usually located either in the engine compartment or under the dashboard. Open the fuse box cover and locate the fuse that corresponds to the affected electrical component. Use the fuse puller tool or a pair of needle-nose pliers to gently remove the fuse from its socket. Inspect the old fuse to determine if it is blown, and if so, replace it with a new fuse of the same amperage rating. Insert the new fuse into the appropriate socket, ensuring it is securely seated, then close the fuse box cover.

How do I replace a headlight bulb in a Spyker C8 LAVIOLETTE SWB?

To replace a headlight bulb in a Spyker C8 LAVIOLETTE SWB, first, open the hood and locate the back of the headlight assembly. Disconnect the electrical connector from the back of the bulb, then twist the bulb counterclockwise to remove it from the housing. Insert the new bulb into the housing, making sure it is securely in place, then reconnect the electrical connector. Finally, test the headlight to ensure it is functioning properly.

How do I replace the cabin air filter in a Spyker C8 LAVIOLETTE SWB?

To replace the cabin air filter in a Spyker C8 LAVIOLETTE SWB, locate the cabin air filter housing, which is typically located behind the glove compartment or under the dashboard. Open the housing by releasing any clips or screws, then remove the old filter. Inspect the housing for any debris and clean it if necessary. Install the new cabin air filter, ensuring it is properly aligned with the housing. Finally, secure the housing back in place and test the air conditioning and ventilation system for proper operation.

How do I reset the maintenance light in a Spyker C8 LAVIOLETTE SWB?

To reset the maintenance light in a Spyker C8 LAVIOLETTE SWB, turn the ignition switch to the "ON" position without starting the engine. Locate the trip odometer button on the instrument cluster and press and hold it down. While holding the button, turn the ignition switch to the "OFF" position, then back to the "ON" position. Continue holding the trip odom

How often should I change the spark plugs in a Spyker C8 LAVIOLETTE SWB?

The recommended interval for changing spark plugs in a Spyker C8 LAVIOLETTE SWB can vary depending on factors such as driving conditions and the type of spark plugs used. Generally, it is recommended to inspect and replace spark plugs every 30,000 to 50,000 miles or as specified in the vehicle's manual. Regularly checking the spark plugs and replacing them when necessary can help ensure optimal engine performance and fuel efficiency.

What is the recommended tire pressure for a Spyker C8 LAVIOLETTE SWB?

The recommended tire pressure for a Spyker C8 LAVIOLETTE SWB can vary depending on factors such as load, driving conditions, and tire size. However, as a general guideline, the recommended tire pressure for this vehicle is typically around 32-35 psi (pounds per square inch) for both front and rear tires. It is important to check and adjust the tire pressure regularly to ensure proper handling, tire wear, and fuel efficiency. Refer to the vehicle's manual or the tire placard located on the driver's side door jamb for the precise recommended tire pressure values.

What type of coolant should I use in a Spyker C8 LAVIOLETTE SWB?

The recommended coolant for a Spyker C8 LAVIOLETTE SWB is a high-quality, ethylene glycol-based coolant that meets the vehicle manufacturer's specifications. It is important to use coolant that is specifically formulated for use in aluminum engines, as this will help prevent corrosion and maintain optimal engine performance. Always refer to the vehicle's manual for the exact coolant type and specifications.