Toyota FJ60 Workshop Manuals and Repair Manuals

To change the oil in a Toyota FJ60, begin by locating the oil drain plug underneath the vehicle. Use a wrench to remove the drain plug and allow the old oil to fully drain out. Once drained, replace the drain plug and remove the oil filter. Install a new oil filter and pour in the recommended amount of fresh oil, ensuring it is the correct viscosity for your FJ60.

To check and top up the transmission fluid in your Toyota FJ60, start the engine and let it idle for a few minutes to warm up. Locate the transmission dipstick, usually near the back of the engine bay, and remove it. Wipe the dipstick clean, reinsert it fully, and then remove it again to check the fluid level. Add the recommended transmission fluid, a little at a time, until the level reaches the "full" mark on the dipstick.

If you are experiencing a misfiring engine in your Toyota FJ60, there are a few potential causes to consider. Start by checking the spark plugs and ignition wires for any signs of wear or damage. Inspect the fuel injectors for clogging or leaks, and ensure the air filter is clean. If the issue persists, it may be necessary to have the engine's timing and compression checked by a professional mechanic.

If you suspect a leaking radiator in your Toyota FJ60, start by inspecting the radiator for any visible signs of coolant leakage. Additionally, check the radiator hoses and connections for any cracks or leaks. If a leak is present, it may be necessary to replace the radiator or repair the damaged area using a suitable radiator sealant. It is advisable to consult a professional mechanic for a thorough diagnosis and proper repair.

To replace a broken taillight on your Toyota FJ60, begin by accessing the rear of the taillight assembly from inside the vehicle. Locate the retaining screws or clips and remove them to release the taillight. Disconnect the wiring harness and remove the old taillight. Install the new taillight, reconnect the wiring harness, and secure it using the retaining screws or clips.

To replace a damaged door handle on your Toyota FJ60, start by removing the interior door panel to access the handle assembly. Disconnect the linkage rods or cables connected to the handle and remove any retaining screws. Install the new door handle, reconnect the linkage rods or cables, and secure it with the retaining screws. Finally, reattach the interior door panel.

To replace a faulty alternator in your Toyota FJ60, begin by disconnecting the negative battery cable to prevent electrical shock. Remove the drive belt from the alternator pulley, followed by the electrical connections and mounting bolts. Take note of the routing of the electrical connections before removing them. Install the new alternator, securing it with the mounting bolts, reconnect the electrical connections, and reinstall the drive belt.

To replace a faulty fuel pump in your Toyota FJ60, begin by disconnecting the negative battery cable. Relieve the fuel system pressure by carefully removing the fuel pump fuse or relay and starting the engine until it stalls. Disconnect the electrical connections and fuel lines from the fuel pump, and then remove the mounting bolts or screws. Install the new fuel pump, reconnect the electrical connections and fuel lines, and reconnect the negative battery cable.

To replace a worn clutch in your Toyota FJ60, start by disconnecting the negative battery cable and removing the driveshaft. Remove the transmission, following the manufacturer's instructions in the repair manual. Once the transmission is removed, access the clutch assembly and remove the pressure plate, clutch disc, and release bearing. Install the new clutch components in the correct order, ensuring proper alignment, and reassemble the transmission and driveshaft.

To replace a worn serpentine belt in your Toyota FJ60, locate the tensioner pulley and use a wrench to relieve the tension on the belt. Slide the old belt off the pulleys and carefully route the new belt, following the diagram located on the engine compartment. Once the new belt is correctly installed, release the tensioner pulley to apply the proper tension.

If your Toyota FJ60's air conditioning system is not functioning correctly, start by checking the fuse related to the A/C system and replace it if needed. Ensure that the blower motor is receiving power and that the A/C controls are set correctly. If the issue persists, it may be necessary to have the refrigerant levels checked by a professional technician, as low refrigerant can cause poor cooling performance.

If you are experiencing issues with your Toyota FJ60's starter, there are a few troubleshooting steps you can take. First, ensure that the battery is fully charged and that the connections are clean and tight. If the battery and connections are in good condition, check the starter solenoid for any signs of damage or wear. If necessary, remove the starter and have it tested at an automotive parts store.

It is generally recommended to change the spark plugs in your Toyota FJ60 every 30,000 to 45,000 miles, or as advised by your vehicle's specific maintenance schedule. Regularly replacing the spark plugs ensures proper combustion and efficient engine performance. When changing the spark plugs, inspect the condition of the ignition wires and replace them if necessary.

The recommended tire pressure for a Toyota FJ60 typically ranges between 28 to 32 PSI (pounds per square inch), depending on the specific model and tire size. It is essential to maintain the correct tire pressure to ensure proper handling, tire wear, and fuel efficiency. Refer to your vehicle's owner manual or the tire placard located on the driver's side door jamb for precise tire pressure information.

For optimal performance, it is recommended to use a high-quality ethylene glycol-based coolant in your Toyota FJ60. This type of coolant provides excellent protection against freezing, boiling, and corrosion. Ensure that the coolant you choose is specifically formulated for use in automobiles and meets the manufacturer's specifications.