Toyota Tercel Workshop Manuals and Repair Manuals
Every Manual available online - found by our community and shared for FREE. Enjoy!
Toyota TercelThe Tercel is a subcompact manufactured by Toyota from 1978 to 1999 across five generations, in five body configurations sized between the Corolla and the Starlet. The Tercel was the first front-wheel-drive vehicle produced by Toyota, establishing a layout and frame that was later used in other popular Toyota models. It was built as front-engine, four-wheel or front-wheel drive. It was available with both diesel and petrol engines, and this model was manufactured with four-speed or five-speed manual and automatic transmission styles.
Toyota Tercel FAQ's
How do I bleed the brakes on a Toyota Tercel?
To bleed the brakes on a Toyota Tercel, start by ensuring the brake fluid reservoir is filled to the recommended level. Begin at the wheel farthest from the master cylinder (usually the rear passenger side) and have a helper pump the brake pedal several times before holding it down. Loosen the bleeder valve, allowing the old brake fluid and any air bubbles to escape. Repeat this process for each wheel, moving closer to the master cylinder, until all air is purged from the brake system.
How do I change the brake pads on a Toyota Tercel?
To change the brake pads on a Toyota Tercel, start by safely lifting the vehicle and removing the wheel. Locate the brake caliper and remove the bolts securing it to the brake assembly. Carefully remove the caliper, take out the old brake pads, and install the new ones. Before reassembling, ensure the caliper piston is properly compressed and that all components are secure.
How do I change the oil in a Toyota Tercel?
To change the oil in a Toyota Tercel, start by locating the oil drain plug underneath the car and placing an oil pan beneath it. Remove the plug using a wrench, allowing the old oil to drain completely. Once drained, replace the drain plug and remove the old oil filter. Install a new oil filter, tighten it securely, and then refill the engine with the recommended amount of fresh oil.
How do I check and adjust the tire pressure in a Toyota Tercel?
To check and adjust the tire pressure in a Toyota Tercel, start by obtaining a tire pressure gauge. Remove the valve cap from the tire, place the gauge onto the valve stem, and read the pressure displayed. Compare this reading to the recommended tire pressure outlined in the owner's manual or on the sticker inside the driver's door jamb. If adjustments are necessary, add or release air until the desired pressure is achieved.
How do I diagnose a Toyota Tercel's check engine light?
When the check engine light illuminates in a Toyota Tercel, it signifies a potential issue with the vehicle's engine or emissions system. To diagnose the problem, it is recommended to use an OBD-II scanner to retrieve the trouble codes stored in the vehicle's computer. These codes can provide valuable information about the specific issue causing the check engine light to turn on. Once the codes are retrieved, consulting the Toyota Tercel repair manual or seeking professional assistance can help identify and resolve the underlying problem.
How do I replace a Toyota Tercel's air filter?
To replace the air filter in a Toyota Tercel, locate the air filter housing, usually found on top of the engine. Open the housing by removing the clips or screws securing it, and carefully lift off the cover. Take out the old air filter and replace it with a new one, ensuring it is properly seated. Finally, reattach the cover and secure it tightly.
How do I replace a Toyota Tercel's fuel filter?
To replace the fuel filter in a Toyota Tercel, first, relieve the fuel system pressure by disconnecting the fuel pump fuse or relay and starting the engine until it stalls. Locate the fuel filter, typically near the fuel tank or along the fuel line, and disconnect the fuel lines from the filter. Remove the old fuel filter and install the new one, ensuring the flow direction is correct. Finally, reconnect the fuel lines and restore the fuel system pressure.
How do I replace a Toyota Tercel's oxygen sensor?
Replacing the oxygen sensor in a Toyota Tercel typically involves locating the sensor, usually threaded into the exhaust manifold or exhaust pipe. Disconnect the electrical connector from the sensor and use an oxygen sensor socket or a wrench to remove it. Install the new oxygen sensor, ensuring it is tightened correctly, and reconnect the electrical connector. It is essential to use a compatible replacement sensor and to follow any specific instructions provided in the Toyota Tercel repair manual.
How do I replace a Toyota Tercel's serpentine belt?
Replacing the serpentine belt in a Toyota Tercel requires releasing the tension on the belt using a tensioner tool or a wrench. Begin by locating the tensioner pulley and rotating it counterclockwise to relieve the tension. Slide the old belt off the pulleys and route the new belt around the pulleys according to the belt routing diagram. Finally, release the tensioner, ensuring the belt is properly seated on all pulleys.
How do I replace a Toyota Tercel's timing belt?
Replacing the timing belt in a Toyota Tercel requires some mechanical expertise. Begin by disconnecting the negative battery cable and removing any necessary components blocking access to the timing belt cover. Next, loosen the tensioner pulley and remove the old timing belt. Before installing the new timing belt, ensure that all timing marks are aligned correctly and follow the specific instructions provided in the Toyota Tercel repair manual to complete the replacement process.
How do I troubleshoot a Toyota Tercel's electrical system?
When troubleshooting the electrical system of a Toyota Tercel, it is crucial to begin by checking the battery's condition and connections. Ensure the battery is fully charged and the terminals are clean and tight. If the battery is in good condition, proceed to inspecting the fuses, relays, and wiring for any signs of damage or loose connections. If necessary, consult the Toyota Tercel repair manual for specific electrical diagrams and troubleshooting steps.
How often should I change the spark plugs in a Toyota Tercel?
It is recommended to change the spark plugs in a Toyota Tercel every 30,000 to 60,000 miles, or as specified in the owner's manual. Worn or faulty spark plugs can cause poor engine performance, reduced fuel efficiency, and difficulty starting the vehicle. Regularly inspecting and replacing the spark plugs will help maintain optimal engine performance and fuel economy.
What type of coolant does a Toyota Tercel use?
A Toyota Tercel typically uses ethylene glycol-based coolant with a 50/50 mix of coolant and distilled water. This ensures proper cooling and protection against freezing and overheating. It is important to choose a coolant that meets the specifications outlined in the Toyota Tercel's owner's manual and to never mix different types of coolant.
What type of engine oil should I use in a Toyota Tercel?
The recommended engine oil for a Toyota Tercel depends on the specific model and year. It is crucial to refer to the owner's manual or repair manual for the correct viscosity and quality grade. Typically, a multi-viscosity oil, such as 5W-30 or 10W-30, with an API certification of SM or higher, is suitable for most Toyota Tercel models.
Why is my Toyota Tercel's engine overheating?
There are several possible reasons for a Toyota Tercel's engine to overheat, including a malfunctioning thermostat, a leaking radiator, a faulty water pump, or a low coolant level. It is important to address this issue promptly to avoid potential engine damage. Check and replace the thermostat if necessary, inspect the radiator for leaks, ensure the water pump is functioning properly, and verify the coolant level is within the recommended range.
Get notified for new manuals?
We'll send you a quick email when a new Toyota Tercel manual is added.