Volvo 245 Workshop Manuals and Repair Manuals
Every Manual available online - found by our community and shared for FREE. Enjoy!
Volvo 245
The Volvo 200 series is a range of executive cars produced by Volvo from 1974 to 1993, with more than 2.8 million units sold worldwide. The Volvo 240 and 260 series was introduced in the autumn of 1974, and was initially available as five variations of the 240 Series (242L, 242DL, 244DL, 244GL, 245L and 245DL) and two variations of the 260 Series (264DL and 264GL). This model was available with various petrol and diesel engines, both manual and automatic transmission styles were manufactured. By June 1982, with the introduction of the model year 1983 Volvos, the third digit too lost its meaning and the 242/244/245 became simply the 240.Volvo 245 FAQ's
How can I replace a headlight bulb in a Volvo 245?
To replace a headlight bulb in a Volvo 245, start by opening the hood and locating the back of the headlight assembly. Disconnect the electrical connector from the bulb by gently pulling it off. Depending on the specific bulb type, either twist it counterclockwise or release the retaining clip to remove the old bulb. Install the new bulb by reversing the removal process, ensuring it is securely seated. Reconnect the electrical connector and test the headlight before closing the hood.
How can I replace the brake pads on a Volvo 245?
To replace the brake pads on a Volvo 245, start by securing the vehicle on jack stands and removing the wheels. Locate the brake caliper, and remove the bolts holding it in place. Carefully lift the caliper off the brake rotor and suspend it with a wire or bungee cord to prevent strain on the brake hose. Take out the old brake pads and install the new ones, making sure they are properly aligned with the caliper and rotor. Reinstall the brake caliper, tighten the bolts, and repeat the process for the other side.
How can I replace the serpentine belt in a Volvo 245?
To replace the serpentine belt in a Volvo 245, start by locating the belt routing diagram, usually found on a decal under the hood or in the owner's manual. Use a wrench or tensioner tool to relieve the tension on the belt, and then slide it off the pulleys. Install the new belt according to the diagram, ensuring it is properly seated on each pulley. Release the tensioner, allowing it to apply tension to the new belt. Finally, visually inspect the belt to ensure it is aligned correctly and running smoothly on all pulleys.
How can I troubleshoot an electrical issue in a Volvo 245?
If you are experiencing an electrical issue in your Volvo 245, start by checking the fuse box for any blown fuses. Use the owner's manual or the fuse box cover to locate the specific fuse related to the problematic circuit. If the fuses are intact, inspect the wiring harnesses and connectors for any signs of damage or loose connections. Additionally, check the battery terminals to ensure they are clean and securely tightened. If the issue persists, it is advisable to consult a professional mechanic or refer to the vehicle's repair manual for detailed electrical troubleshooting procedures.
How do I change the oil in a Volvo 245?
To change the oil in a Volvo 245, start by locating the oil drain plug underneath the engine. Place a drain pan underneath the plug, and then use a wrench to unscrew the plug, allowing the old oil to drain out completely. Once the oil has drained, replace the drain plug and tighten it securely. Locate the oil filter, usually located near the oil pan, and use an oil filter wrench to remove it. Before installing the new oil filter, apply a thin layer of oil to the rubber gasket to ensure a proper seal. Screw on the new oil filter by hand, and then refill the engine with the recommended amount and type of oil.
How do I diagnose a brake fluid leak in a Volvo 245?
If you suspect a brake fluid leak in your Volvo 245, start by visually inspecting the brake lines, calipers, and master cylinder for any signs of fluid accumulation or wetness. Check the brake fluid reservoir to ensure it is filled to the recommended level. If there is a noticeable drop in fluid level, it may indicate a leak. To confirm the source of the leak, clean the suspected area thoroughly and use a flashlight to check for any active leaks. If a leak is found, it is crucial to address the issue promptly by repairing or replacing the damaged component.
How do I replace the air filter in a Volvo 245?
To replace the air filter in a Volvo 245, locate the air filter housing, which is usually located in the engine compartment. Remove the screws or clips securing the housing cover, and carefully lift off the cover. Take out the old air filter, making sure to note the direction of airflow indicated on the filter. Insert the new air filter in the same position, ensuring it is properly seated, and then replace the housing cover and secure it with the screws or clips.
How do I replace the cabin air filter in a Volvo 245?
To replace the cabin air filter in a Volvo 245, start by locating the filter housing, which is usually located behind the glove compartment. Open the glove compartment and remove any contents. Release the glove compartment stops by pushing inward on the sides,
How do I troubleshoot a starting problem in a Volvo 245?
If you are experiencing a starting problem in your Volvo 245, start by checking the battery connections to ensure they are clean and tight. Verify that the battery has sufficient charge by using a multimeter or a battery tester. If the battery is in good condition, check the ignition switch and starter solenoid for any signs of damage or malfunction. Additionally, inspect the fuel system for any clogged filters or fuel pump issues. If the problem persists, it is advisable to consult a professional mechanic or refer to the vehicle's repair manual for further troubleshooting steps.
What are the steps to change the spark plugs in a Volvo 245?
To change the spark plugs in a Volvo 245, start by locating the spark plug wires connected to the engine. Carefully disconnect the wires from the spark plugs, making sure to label them if needed. Use an appropriate spark plug socket and ratchet to remove the old spark plugs. Before installing the new spark plugs, ensure they are the correct type and properly gapped. Carefully thread in the new spark plugs by hand, and then use the spark plug socket and ratchet to tighten them to the recommended torque specification.
What are the steps to replace a tail light assembly in a Volvo 245?
To replace a tail light assembly in a Volvo 245, start by opening the trunk or tailgate and locating the back of the assembly. Remove any screws or fasteners holding the assembly in place, and then carefully pull it away from the vehicle. Disconnect the electrical connector from the assembly by releasing any retaining clips or tabs. Install the new tail light assembly by reversing the removal process, making sure it is properly aligned and securely fastened. Test the tail lights before closing the trunk or tailgate.
What are the steps to replace the fuel filter in a Volvo 245?
To replace the fuel filter in a Volvo 245, start by locating the filter, which is typically found along the fuel line, either near the fuel tank or near the engine. Use a wrench to loosen the fittings on both sides of the filter, making sure to have a catch pan ready to collect any fuel that may spill. Remove the old filter and install the new one, making sure to tighten the fittings securely. Once the new filter is in place, turn the ignition key to the "On" position without starting the engine, and check for any signs of fuel leaks.
What should I do if the engine overheats in my Volvo 245?
If the engine in your Volvo 245 is overheating, the first step is to safely pull over and turn off the engine to prevent further damage. Allow the engine to cool down for at least 30 minutes before attempting any inspection or repairs. Check the coolant level in the radiator and reservoir, and if it is low, add a 50/50 mixture of coolant and water to bring it to the proper level. Inspect the radiator hoses for any signs of leaks or damage, and check the radiator fins for debris or blockages. If the issue persists, it is recommended to have the cooling system inspected by a qualified mechanic.
What should I do if the steering feels loose in my Volvo 245?
If the steering in your Volvo 245 feels loose, the first step is to check the power steering fluid level. Locate the power steering fluid reservoir, usually located near the engine, and ensure the fluid level is within the recommended range. If the fluid level is low, add the appropriate power steering fluid to bring it to the correct level. Inspect the power steering belt for any signs of wear or looseness, and adjust or replace it if necessary. If the issue persists, it is recommended to have the steering system inspected by a qualified mechanic.
Volvo 245 on Amazon
Volvo 245 Owners Manual
-
- Volvo 245 1976 Owners Manual
- (105 Pages)
- (Free)
-
- Volvo 245 1977 Owners Manual
- (105 Pages)
- (Free)
-
- Volvo 245 1978 Owners Manual
- (105 Pages)
- (Free)
-
- Volvo 245 1979 Owners Manual
- (30 Pages)
- (Free)
-
- Volvo 245 1979 Owners Manual USA and Canada
- (30 Pages)
- (Free)
Volvo 245 Misc Document
- (Free)
- (Free)
- (Free)
- (Free)
Related Models