Nissan Terrano Workshop Manuals and Repair Manuals

To change the oil in a Nissan Terrano, first warm up the engine, then locate the oil drain plug underneath the vehicle. Remove the plug and let the old oil drain completely. Afterward, replace the drain plug and refill the engine with the recommended amount and type of oil specified in the manual, making sure not to overfill.

To check and top up the brake fluid in a Nissan Terrano, start by locating the brake fluid reservoir under the hood. Remove the cap and visually inspect the fluid level, ensuring it is between the MIN and MAX markings. If necessary, add the recommended brake fluid specified in the vehicle's manual. Take extra care not to introduce any contaminants into the brake fluid system while performing this task.

To check the engine coolant level in a Nissan Terrano, ensure the engine is cool and parked on a level surface. Locate the coolant reservoir under the hood and visually inspect the coolant level, which should be between the MIN and MAX markings. If necessary, add a mixture of coolant and distilled water as recommended in the vehicle's manual. Take caution not to open the radiator cap when the engine is hot to avoid injury.

To check the power steering fluid in a Nissan Terrano, locate the power steering fluid reservoir under the hood. Clean the reservoir cap before removing it, then visually inspect the fluid level, which should be between the MIN and MAX markings. If necessary, add the recommended power steering fluid as specified in the vehicle's manual. Be careful not to overfill the reservoir, as it can lead to foaming and compromised power steering operation.

To check the transmission fluid in a Nissan Terrano, ensure the vehicle is on a level surface and the engine is warm. Locate the transmission dipstick, usually near the back of the engine bay. Pull out the dipstick, wipe it clean, reinsert it fully, and then remove it again. Check the fluid level against the "HOT" range on the dipstick. If necessary, add the recommended transmission fluid as specified in the manual.

To jump-start a Nissan Terrano, you will need a functioning vehicle and jumper cables. Begin by positioning the vehicles close to each other but not touching. Turn off both engines and connect the positive jumper cable clamp to the positive terminal of the dead battery. Attach the other positive clamp to the positive terminal of the working battery. Connect the negative clamp to the negative terminal of the working battery and the other negative clamp to a metal surface away from the dead battery. Start the working vehicle, wait a few minutes, then start the Nissan Terrano.

To replace a headlight bulb in a Nissan Terrano, start by opening the hood and locating the back of the headlight assembly. Disconnect the electrical connector from the bulb, then twist and remove the bulb from its socket. Install the new bulb by aligning the tabs and twisting it into place. Finally, reconnect the electrical connector and test the headlight to ensure proper functioning.

To replace the battery in a Nissan Terrano, start by ensuring the engine is off and the vehicle is in park with the parking brake engaged. Locate the battery, usually under the hood on one side of the engine bay, and disconnect the negative terminal first using a wrench or pliers. Proceed to disconnect the positive terminal in the same manner. Remove any additional brackets or fasteners securing the battery, then lift it out of the battery tray. Install the new battery in the reverse order, reconnecting the positive terminal first and then the negative terminal.

To replace the cabin air filter in a Nissan Terrano, start by locating the filter housing, which is usually behind the glove compartment. Open the glove compartment and remove any contents or restraining straps, then squeeze the sides of the compartment to allow it to drop down. Locate the filter housing cover, remove it, and take out the old filter. Install the new filter, ensuring it is properly aligned, then reassemble the filter housing and glove compartment.

To replace the spark plugs in a Nissan Terrano, start by locating the spark plug wires or ignition coils. Disconnect these wires or coils from the spark plugs, then use a spark plug socket and ratchet to remove the old spark plugs. Check the gap on each new spark plug using a gap gauge, adjust if necessary, and install them by hand before tightening with the socket and ratchet. Finally, reconnect the spark plug wires or ignition coils to complete the replacement process.

To replace the windshield wipers on a Nissan Terrano, start by lifting the wiper arm away from the windshield and locating the release tab or button on the wiper blade. Press or slide the tab/button to release the old wiper blade, then insert the new blade into the wiper arm until it clicks into place. Gently lower the wiper arm back onto the windshield, and repeat the process for the other wiper.

To reset the maintenance reminder in a Nissan Terrano, turn the ignition switch to the "ON" position without starting the engine. Within ten seconds, press and hold the trip meter reset button until the maintenance reminder resets to zero. Release the button and turn off the ignition. The maintenance reminder should now be reset, and the next maintenance interval will be accurately displayed.

The air filter in a Nissan Terrano should be replaced at regular intervals, typically every 12,000 to 15,000 miles or as indicated in the vehicle's manual. However, the replacement frequency may vary depending on driving conditions and environmental factors. It is important to inspect the air filter regularly and replace it when it is visibly dirty or clogged to maintain proper airflow and engine performance.

The recommended tire pressure for a Nissan Terrano can vary depending on the specific model and tire size. It is crucial to refer to the placard located on the driver's side door jamb or consult the vehicle's manual for the accurate tire pressure specifications. Proper tire pressure ensures optimal handling, fuel efficiency, and tire longevity, so it is essential to check and adjust tire pressure regularly.

For a Nissan Terrano, it is recommended to use a high-quality ethylene glycol-based coolant that meets the specifications outlined in the vehicle's manual. This coolant should provide proper corrosion protection and be mixed with distilled water to achieve the correct concentration. It is crucial to follow the guidelines in the manual to ensure optimal cooling system performance and prevent any potential damage or overheating.